Product Details
DB-15S Road marking paint series
Ⅰ、Introduction
1. Composition: the product is mainly made up of propionic acid resin, pigment, physical pigment, auxiliary agent and organic solvent.
2.Features: the product has fast drying film, good adhesion, excellent UV resistance, good outdoor durability, and can be used in low temperature conditions
3.Application: the product is mainly used for asphalt and concrete pavement as road marking coating.
4.Heating solvent road marking coating: high solid content, less solvent, fast drying, good reflective effect, widely used in high-grade highways abroad
5.Marking tape marking tape refers to that marking material is made in advance in the factory, the surface is embedded with glass beads, which can reflect light, and the back can be pasted on the road.The marking belt can be divided into permanent marking belt and temporary marking belt.It is mainly used in high wear area of arrow and maintenance.
6.At present, the commonly used road marking coatings in China are solvent normal temperature type and hot-melt type.
Ⅱ、Technical parameters
|
Project |
Index |
Test method |
|
Film appearance |
No wrinkling, floating color, cracking and sticking |
GB/9761-88 |
|
Viscosity (coating-4 cups) S |
Not less than 80 |
GB/T1723-93 |
|
Fineness (μm) |
No more than 40 |
GB/T1724-79 |
|
Covering power (g / m2) |
No more than 200 |
GB/T1726-79 |
|
Drying time (minutes) |
No more than 15 |
GB/T1731 |
|
Flexibility (4mm) |
No cracking and falling |
GB/T9265-88 |
|
Wear resistance（mg） |
No more than 50 |
GB/T1768-79 |
Ⅲ、 Construction reference
1. Before applying the paint, the road surface to be coated shall be cleaned to ensure that there is no impurity and oil stain.
2. The product can be sprayed, brushed or rolled.
3. If the paint is too thick during construction, it must be diluted with special diluent to the required consistency.
Ⅳ、 Storage
1.The paint and diluent shall be sealed in a cool place to prevent fire, leakage, sun, high temperature and fire.
2.The storage period of coating is more than one year.
3. After opening the tank, the paint shall be stirred evenly to prevent the color difference caused by the pigment sinking.
4. If there are dust, particles, oil and other attachments on the surface of the workpiece, it will damage the appearance, so it should be wiped clean before spraying.
5. Due to different plastic substrates, the test shall be conducted before spraying to avoid affecting the adhesion of the paint.
6. During the construction, please do a good job in labor protection, wash the skin contact coating with washing powder and water, and seek medical help in case of discomfort.
