DB-7G Epoxy Anti-Rust And Anti-Corrosion Paint Series

1. Introduction

DB-7G706 epoxy zinc-rich primer is mainly composed of epoxy resin, zinc powder, anti-rust pigments, fillers, additives, solvents, etc. The epoxy zinc-rich primer is epoxy resin, epoxy resin as A class of coatings that are mainly film-forming substances, with excellent adhesion and chemical corrosion resistance, good alkali resistance, and hard coating; it is the most important anti-corrosion paint product, mainly used for corrosion-resistant coating, epoxy rich Zinc primers are often used as primers for anti-corrosion paints.

2. Features

It has excellent adhesion and chemical corrosion resistance, good rust resistance, good salt spray resistance, strong adhesion, excellent acid resistance, excellent alkali resistance, oil resistance, and can comprehensively improve the corrosion resistance and service life of steel structure substrates.

3. Features Introduction

This product is a two-component epoxy coating product, which has the physical and chemical properties of strong adhesion, tough paint film, excellent alkali resistance, oil resistance, salt spray resistance, and chemical gas corrosion resistance. paint to use.

4. Technical indicators

5. Scope of application

Mechanical equipment, petrochemical equipment, outer walls of various storage tanks, heavy steel structures, port machinery, railway and road transport vehicles, bridges, ships.

6. Construction instructions

Epoxy anti-corrosion primer ratio: 5kg (oil): 1kg (solid): 1kg (thin)

Brush or spray the epoxy anti-corrosion primer one or two times: After fully stirring the prepared epoxy anti-corrosion primer, it is mixed with epoxy curing agent and thinner in proportion, and fully stirred for 1 to 2 minutes. construction.

7. Precautions

The paint should be fully stirred before use, and must be used up within 4 hours after mixing with the curing agent, so as not to affect the effect.

8. Storage and safety protection

1. The product should be stored in a cool and ventilated place, prevent direct sunlight, and isolate the fire source, away from the heat source;

2. Operators should wear safety masks and gloves to avoid contact with skin or eyes, and should be washed with clean water in case of accidental contact.