Epoxy Anti-rust and Anti-corrosion Paint Series

1. Introduction

DB-7G706 Epoxy Zinc Rich Primer is mainly composed of epoxy resin, zinc powder, anti-rust pigments, fillers, additives, solvents, etc. Epoxy zinc-rich primer is a type of coating with epoxy resin as the main film-forming substance, possessing excellent adhesion, chemical corrosion resistance, good alkali resistance, and a hard coating. It is the most important anti-corrosion paint product, mainly used for anti-corrosion coating. Epoxy zinc-rich primer is usually used as a primer for anti-corrosion paints.

2. Features

Possesses excellent adhesion and chemical corrosion resistance, good rust prevention performance, good salt spray resistance, strong adhesion, excellent acid and alkali resistance, oil resistance, and can comprehensively improve the anti-corrosion performance and service life of steel substrates.

3. Characteristics Introduction

This product is a two-component epoxy coating, featuring strong adhesion, tough paint film, excellent alkali resistance, oil resistance, salt spray resistance, and chemical gas corrosion resistance. It is used as an anti-corrosion or anti-rust primer for steel and non-ferrous metals.

4. Technical Specifications

5. Scope of Application

Mechanical equipment, petrochemical equipment, exterior walls of various storage tanks, heavy steel structures, port machinery, rail and road transport vehicles, bridges, ships.

6. Construction Instructions

Epoxy Anti-corrosion Primer Ratio: 5 kg (paint) : 1 kg (hardener) : 1 kg (thinner)

Brush or spray 1 to 2 coats of epoxy anti-corrosion primer: After thoroughly stirring the prepared epoxy anti-corrosion primer, mix it with the epoxy hardener and thinner according to the specified ratio, stir thoroughly for 1~2 minutes, then it can be applied.

7. Precautions

The paint should be thoroughly stirred before use. After mixing with the hardener, it must be used within 4 hours to avoid affecting the performance.

8. Storage and Safety Protection

1. The product should be stored in a cool, ventilated place, away from direct sunlight, isolated from fire sources, and far from heat sources;

2. Operators should wear safety masks and gloves to avoid contact with skin or eyes. If accidental contact occurs, wash with clean water.